Bootcamp Inventory
Hardware used during the Physical AI Bootcamp — powered by Robu.in and Arduino.cc.
info
Hardware Policy All Arduino Q boards and sensor modules used during the workshop will either be collected at the end of the bootcamp or made available for on-the-spot purchase. A consolidated inventory report will be shared with the Robu and Arduino teams.
Shared sensor kits will be retained and reused across future bootcamps.
Core Kits
One per participant (25 units per batch)
| Item | Qty | Purpose |
|---|---|---|
| Arduino Q Board | 1 per kit | Main microcontroller for all projects |
| USB Hub — Arduino USB-C Hub 8-in-1 (TPX00241) | 1 per kit | Connectivity hub for camera, peripherals |
| USB Type-C Cable | 1 per kit | Programming and power supply |
| Breadboard (Mini) | 1 per kit | Circuit prototyping |
| Jumper Wire Sets (M-M, M-F) | 1 set per kit | Circuit connections |
| LEDs (Assorted) | 1 set per kit | Output indicators |
| Resistors (Assorted) | 1 set per kit | Current limiting / Pull-up / Pull-down |
| Push Buttons | 1 set per kit | Manual input testing |
Sensors Pool
Shared across teams — available to borrow during sessions
| Item | Qty | Interface | Purpose |
|---|---|---|---|
| USB Camera | 25 | USB | Image classification and sound capture |
| Microphone Module (if USB camera not available) | ~5 | I2C / USB | Sound classification projects |
| IMU Module (Accelerometer + Gyro) | ~5 | I2C | Motion and gesture detection |
| Ultrasonic Sensor (HC-SR04) | ~5 | Digital | Distance sensing for robotics |
| Temperature Sensor | 5 | Digital / Analog | Environmental monitoring |
| Vibration Sensor | 5 | Digital / Analog | Anomaly detection |
| Light Sensor (LDR / Digital) | 5 | Analog / Digital | Ambient detection systems |
| OLED Display Module (Optional) | 5 | I2C | Visual output display |
Robotics Pool
Available for advanced / robotics-focused teams
| Item | Qty | Purpose |
|---|---|---|
| Robot Chassis Kit (2WD) | 5 | Intelligent robotic systems |
| Motor Driver Module | 5 | Motor speed and direction control |
| DC Motors (BO) | 5 | Drive wheels |
| Rechargeable Battery Pack | 5 | Robot power supply |
| Battery Charger | 3 | Charging between sessions |
Hardware Handling Rules
- Handle the Arduino Q board by the edges — avoid touching components directly
- Do not apply voltages above 3.3 V to GPIO pins unless specified
- Always double-check wiring before powering up
- Return all shared sensors to the pool at the end of each session
- Robotics kits — return fully assembled and charged
tip
Missing Something? If an item is missing from your kit, notify the facilitator before the session starts. Spare units are available.